AU-32 / AU-31 ANALOG MULTITESTER – SANWA
AU-32 / AU-31
Analog Multitesters High input impedance
Auto range, High input impedance
BASIC FEATURES:
- Auto range selection (V, Ω)
- Auto polarity
- High input impedance 1〜10MΩ
- Series capacitor input ※AU-31 ACV only
- Auto 0Ω adjustment
- Inner battery check
- DC / AC auto selection ※AU-32 only
- 5 ranges DC / AC current ※AU-32 only
Bandwidth : 40〜10kHz (0.25V : ±5%), 40〜600Hz
(2.5V and above : ±5%)
: 40〜10kHz (0.3V : ±5%), 40〜1kHz
(3V and above : ±4%)
SPECIFICATIONS:
OPTIONAL ACCESSORIES:
HV probe : HV-50
Carrying case : C-SP
Clip adapter : CL-11, CL-15a, CL-DG3a, TL-8IC
Test lead : TL-91M
Related products
-
CP – 7D ANALOG MULTITESTER – SANWA
Add To QuoteWide scale with mirror for easy reading of measured values
- Wide scale with mirror
- Fixed test leads for safety and operability
- Employs metal oxide film resistors that are high precision, heat resistant, smokeless
- Battery check
- Internal circuit protection with fuse and diode
-
SP21 ANALOG MULTITESTER – SANWA
Add To QuoteShockproof meter
With continuity check beeper
- Employs shockproof taut-band meter that is not easily damaged even if dropped
- Zero center meter for ± DCV measurement
- Double protection with fuse and diode to protect the internal circuit from overvoltage
- Battery check
- With a tilt stand that helps to read the meter
-
VS – 100 ANALOG MULTITESTER – SANWA
Add To QuoteEmploys current-limiting fuse with 100kA of breaking current
- Tester for maintenance and management for electrical equipment that is suitable for measuring high-power low-voltage circuits(500V or lower)
- Built-in current-limiting fuse cuts off the current at 100kA to reduces the risk of arc discharge
- Hard case included
-
YX – 361TR ANALOG MULTITESTER – SANWA
Add To QuoteVariety of measurement functions by using 24-contact switch
- Employing 24-contact switch and plus alpha function enable you to enjoy a total of 33 functions
- Zero center meter for ± DCV measurement
- With LED for continuity check
- With OUTPUT measurement terminal (series capacitor inserted)
- Battery check
- DC current gain (hFE) of transistor can be measured by using separately available hFE connector
-
EM7000 ANALOG MULTITESTER – SANWA
Add To QuoteHigh sensitivity for measurement of lower capacitance
- High-sensitivity FET electronic tester with high input resistance (2.5M – 12MΩ for DCV) and 0.12μA range (DC current)
- Frequency response against 40Hz to 1MHz of sine wave (AC low voltage)
- Measurement of P-P value (Peak to Peak value) of square wave pulse (duty cycle 20% or higher)
- Wide range resistance measurement from 0.2Ω to 200MΩ
※Zero adjustment needs to be performed before measurement, since the instrument is an electronic tester.
